75 ohm to 120 ohm Coax to RJ45 16E1 Balun Panel

75 ohm to 120 ohm Coax to RJ45 16E1 Balun Panel,19inch rack mount

INFORMATION

Overview:

The coax to RJ45 16E1 balun converter allow 75 Ohm coax to communicate with 120
Ohm twisted pair equipment. The 16E1 balun panel specifically address the
ONP requirement that PTTs offer 120 Ohm twisted pair terminations to their
customers. Some telecommunication equipments output only on 75 Ohm coax,or have
customers whose CPE has only 75 Ohm coax connections. The 75 ohm to 120 ohm balun panel present a ready solution to this termination mismatch by allowing a
bi-directional conversion of coax(75 Ohm )to a twisted pair (120 Ohm
),supporting data rates to E1(2.048Mbps). The signals output by them are scaled
to match the pulse shape requirements specified by the CCITT G.703 standard.

Features:

Data Rates to 2.048 Mbps
75 Ohm to 120 Ohm Twisted Pair （RJ45;
Bi-Directional Signal Conversion
2U high enclosed chasiss
mounts in a standard 19 inch(48.3cm) rack
No AC Power or Batteries Needed
16 Female BNC connector Available
BNC connector and RJ45 connector are front.

Specification:

Transmission Line:	ITU/CCITT G.703(unstructured)
Data Rate:	2.048 Mbps maximum
Unbalanced Coaxial Connection:	Dual coax BNC connectors,female and Nominal Line Impedance=75 Ohms
Balanced Twisted Pair Connection:	Single 8-pin RJ-45 jack,shielded(two twisted-pair),Nominal Line Impedance=120 Ohms
Power Supply:	None required,passive device
Operating Temp:	0-50℃(32-122oF)
Isolation:	1500V rms