Huawei MA5680T is a aggregation Optical
Line Terminal (OLT), it supports up to 14 service slots (19inch type) and can
support maximum 28,000 subscribers (GPON). MA5680T has GICF/X2CS Uplink Board
available for selection, and two power slot redundancy for DC power input.
When I get the huawei GPON OLT MA5680T, I found that only the H805GPFD card works and is already configured but the other 3 cards H806GPFD are not working. How to resolve the problem?
The reason is caused by the difference
firmware of two control card, one version is higher, antoher card version is
low. The chassis run by the low firmware, the high version control card do not run. The user can upgrade the
control card firmware, making two cards firmware version are same. The detail
steps as below:
1. insert the control card with new
version, power on the chassis for more than 10minutes
2. insert the low version control card, run
20minutes
3. run the following commands:
undo rollback standy
save
display version
save
two control card firmware version be same and save it, will be ok.
Baudcom can help you to resolve kinds application problem and rich your FTTH application experience.
More huawei OLT information:
https://www.e1-converter.com/huai_wei_gpon_olt_ont/
